EVENT DATA ENTRY FROM A TH-D7 HT 19 Jan 07 ----------------------------------------------------------------------- Updated 24 Jan 2008 This sheet shows the D7 Walkie-Talkie operator how to enter an APRS message for sending scoring data to NETCON. The radio is dual band and will operate data on UHF and can still be used for voice on VHF. BASICS: Hit the left-joy-stick to ESC out of any mode or menu at any time. Use the DUAL key to toggle on or off the unused A or B side of the radio if desired to save power. Select A or B with the A/B button. DUAL BAND: The D7 is set for band A on the voice frequency of 146.43 MHz and band B on the APRS data channel for this event of 434.35 MHz. POSITION REPORTING: If used, Manually enter the LAT/LONG of your station using the POS key. A list of station positions would be provided for this event or a map with a LAT/LON grid that you interpolate to your position. If used, set automatic position reporting once every 10 minutes via the APRS MENU, set DATA TX = AUTO. Select TX INTERVAL 10. Update your position at any time by toggling the BCON button twice. MESSAGE BASICS: The D7 keypad uses a multi-press key function to enter characters. Pressing the ABC key three times generates the letter "C". Pressing it four times generates "2". If two consecutive characters from the same KEY are needed, press the right-joystick-OK button to move to the next byte position. The "0" key is also the SPACE key. MESSAGE SENDING: Preload a TEST message to NETCON giving a score or report in the anticipated format for the event. In this scout scoring event, enter a message containing a troop number 999 and score 99. This makes future reports easy by only modifying the digits of the previous one. Use these steps to modify an existing message to send a new one: 1) Press MSG key. 2) Select LIST with the OK button (joy stick) 3) This brings up the last message. 4) Right digit, or * indicates number of retries, or ACK received. 5) Press MSG key again to prepare a new msg to same receipient (NETCON) 6) Use up/dn joystick to modify each digit for the new message 7) press OK button to move to next byte 8) press OK at end of message and it will be sent. 9) An ACK will be received eventuallly from NETCON A) The ack will show as a (*) on the message list. CAPACITY: The D7 can hold up to 16 messages. You cannot delet them but each time you enter a new one, or receive a new one, the oldest one will be overwritten. If you get 16 new messages without ever reading any, then the HT will reject any new messages. But once you read at least ONE message, then all 16 are vulnerable to being over- written. So each time you check messages, read all new traffic. POWER SAVING: If the data channel is not too busy, you can use it to do voice chatting as well. This way, you can save power, by turning off the band A channel and then NETCON can always contact you by calling on the data channel by voice. Having the data channel on UHF avoids any interference to the normal event voice channel which is on 2m usually. WB4APR